Adding weight type armature balancing machine software or driver problem
Question: I check the machine start to end
1) First machine switch on
2) Do the balancing new pieces , up 12 pieces is ok
3) After 13 pieces machine become problem. Motor will no run ( switch or food switch ) to press
4) After the machine will switch off .
5) Then machine switch on . do the balancing motor will run .up to become problem
Thanks for your detail description, please follow below step to check and slove:
1. You do the balancing new piece until the machine become problem,
2. Take off the armature
3. Change the Running to Commissioning by press it
4 Use your food to press the pedal to check if the motor run or not
5. If the motor run in Commissioning status, please change the Measuring to Self checking by press it
Check if there will be value appear for L and R, if there is value and it is normal and the sensor should be on,
6. You continue to press the pedal again for half hour, if it is running for half hour, the problem might come from softwre
7. If there is value on L and R, but motor stop, then the problem come from the driver,
Please follow above steps and looking forward to your feedback,