The main difference between diesel and electricity is the heating method,The power consumption has big difference, also the heating temperature control in each zone is different, the heating method by electricity is heating tubes, the heting temperature in each zone could be set up individually, but the heating method by diesel in the burner, the heating temperature in each zone couldn't be adjus...

Opened control panel.Remove all socket from card.Push all IC. Reassembled the socket.Set all parameter once again.Started the machine.

One of the flyers stops working after 15 – 20 minutes and needs to be reset to start againLeft flyer stops, the error no.21 appears. Correct?Then your engineer tighten the encoder wire of left flyer, and do the reset every time while the left flyer stops, finally the machine runs well. Correct?In this case, pls ask your engineer to exchange the encoder wire of left flyer and right flyer. If the pr...

AC drive.Inout is Ok but output is not getting, how to solve? There are two possibility which may cause the problem,1. The inverter have problem2. The black swith for adjusting speed have problem You could verify if inverter problem by below method, Please DO take a picture of the wires connection of inverter firstly for recording the wire connction status, then connect the yellow wire as attach...

Electrical insulation papers are paper types that are used as electrical insulation in many applications due to pure cellulose having outstanding electrical properties. Cellulose is a good isolator and is also polar, having a dielectric constant significantly greater than one.[1] Electrical paper products are classified by their thickness, with tissue considered papers less than 1.5 mils thicknes...

In lacing machine, if the needle could mot move the thread properly, how do you slove it? 1. Adjust the needle position2. You could check if the speed and action of the needle and nozzle are not synchronous, you could adjust the endoder,Actually for changing tooling of the lacing machine, if OD difference is big, adjust the stroke by move the base forward or backwardIf the stack height is changed...

For armature winding machine ND-LAW-2 ( for small wire diameter )The are two methods to slove hook missing problem: Put on the armature, have a check if the position of armature and hook tooling is alignment, Method 1: Adjust the hook tooling a little clockwise or anti-clockwise (based on the situation) after loosening the screws, Method 2: Adjust the indexing value with 1 degree plus or minus(...

Our machines could use for both aluminum and copper wire, the main difference between aluminium and copper is: aluminum is cost saving, weight is lighter, but temperature rise is higher, connection is easier to get broken, and easier to be oxidized,effieiency is less. While copper is more expensive, the other is better

Machinea are not same as daily articles, it is always customer made, when you choose a machine supplier,below are what you should consider: 1. Machine quality 2. Price 3. After-sales service,

Normall for a stator's filling rate below 75%, one time wedge and coil insertion could be achieved, And if below situation, you need to use two times wedge and coil insertion: 1. Filling rate above 80%, 2. There is insulation paper in between the main-winding and aux-winding

For balance the armature, some customer use the adding weight type, while some use the removing weight type? How they choose and decide, If your motor speed is high, such as the power tool motor, you need to use the removing weight type, If your motor is with not high speed, you could use the adding weight type